Renesas EDK3687 Manual de usuario

EDK3687 USER MANUAL FOR H8/3687 ON-CHIP FLASH MICROCONTROLLER

5.2. EDK OPTIONS – CJ4 The EDK options provide access to commonly used features of the EDK range. These jumpers must be fitted at all times to

5.3. OPTION LINK SELECTION The following sections show the option links that apply to each peripheral device. The tables all use the same key of

5.3.3. SPI – SERIAL PERIPHERAL INTERFACE The SPI interface is not directly compatible with the SCI interface on the device. Selection of the conn

6. MICROCONTROLLER HEADER CONNECTIONS The following table lists the connections to each or the headers on the board. 6.1. HEADER J1 J1 Pin No Fun

7. CODE DEVELOPMENT 7.1. HMON 7.1.1. MODE SUPPORT The HMON library is built to support Normal Mode only. 7.1.2. BREAKPOINT SUPPORT The monitor ut

7.1.4. MEMORY MAP On-Chip FLASHROMOn-Chip RAMInternal I/OREGISTERSOn-Chip RAMVectorsFDTInitFDTUserModeMicroKernelPHMONCHMONCUser_VectorsBHMONStac

7.1.5. BAUD RATE SETTING HMON has initially set to connect at 115200Baud. Should the user wish to change this, the value for the BRR in HMONseria

Preface Cautions 1. This document may be, wholly or partially, subject to change without notice. 2. All rights reserved. No one is permitted

1. TABLE OF CONTENTS 1. TABLE OF CONTENTS ...

2. START-UP INSTRUCTIONS 2.1. INSTALLING THE EVALUATION DEVELOPMENT KIT (EDK) Please refer to the quick start guide provided for initial instal

3. EDK BOARD LAYOUT The diagram shows a general layout of the EDK board. 9-WayD-TypePowerRESETSwitchNMISwitchUser1 LEDUser2 LEDPower LEDFLASHProg

4. EDK OPERATION 4.1. USER INTERFACE The EDK provides two buttons for influencing the operation of the board. The purpose of each button is clear

4.2.2. CRYSTAL CHOICE The operating crystal frequency has been chosen to support the fastest operation with the fastest serial operating speeds.

4.4. I2C EEPROM The board has been tested with an Atmel AT24C04AN-10SI-2.7 I2C EEPROM device (Not supplied). The device is configured to connect

5. BOARD OPTIONS The EDK has a number of configuration settings set by four jumpers CJ4 (A, B, C, D) and zero-ohm links. Common EDK functions ca