Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 20)

E1/E20 Emulator Setup

R20UT0398EJ0400 Rev.4.00 Page 20 of 39

May 16, 2014

(2) A connector to the user-system interface cable must be installed on the user system. Table 2.1 shows the

recommended connector for the emulator.

Table 2.1 Recommended Connector

Connector

Type Number

Manufacturer

Specifications

14-pin connector

7614-6002

Sumitomo 3M Limited

14-pin straight type (Japan)

2514-6002

3M Limited

14-pin straight type (other countries)

38-pin connector

2-5767004-2

Tyco Electronics Japan G.K.

38-pin type

(3) For the pin assignments of the connector, refer to the separate MCU-specific manual for the emulator.

(4) Connect one end of the user-system interface cable to the emulator and the other end to the connector on the

user system as shown in Figures 2.3, 2.4, and 2.5.

14-pin user-system interface cable

14-pin connector

7614-6002 or

2514-6002

User system

Pin 1

Pin 2

Figure 2.3 Connecting the User-System Interface Cable to the User System when the 14-Pin

Connector is in Use with the E1

CAUTION

Notes on connector insertion and removal:

When connecting or disconnecting the user-system interfac

e cable and the emulator or user system,

grasp the connector cover at the end of the cable. Pulling the cable itself will damage the wiring.

Correct example

Incorrect example

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 38 39

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 20