Renesas QFP-64A Información técnica

To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C

Section 2 Connection Procedures 2.1 Connecting User System Interface Cable to Emulator Station WARNING Always switch OFF the user system and the

2.2 Connecting User System Interface Cable to User System WARNING Always switch OFF the user system and the emulator product before the USER SY

6 2.2.4 Fastening Cable Head CAUTION 1. Use a Phillips-type screwdriver whose head matches the screw head. 2. The tightening torque must

Screws (M2.0 x 12 mm)and flat washersCable headPin 1IC socket(IC149-064-008-B5manufactured by YAMAICHI ELECTRONICS Co., Ltd.)User system Figure 3 Co

2.2.5 Connecting Cable Body to Cable Head Connect the cable body to the cable head. Cable bodyCable headRemove jigPush the remove jigRemovingUser sy

2.3 Recommended Dimensions for User System Mount Pad Figure 5 shows the recommended dimensions for the mount pad (footprint) for the user system with

2.4 Dimensions for User System Interface Cable Head The dimensions for the user system interface cable head are shown in figure 6. Unit:

2.5 Resulting Dimensions after Connecting User System Interface Cable The resulting dimensions, after connecting the user system interface cable head

12 Section 3 Installing the MCU to the User System CAUTION 1. Check the location of pin 1 before inserting. 2. Use a Phillips-type screwdrive

MCUPin 1 markUser systemSocket coverIC socket (IC149-064-008-B5manufactured by YAMAICHI ELECTRONICS Co., Ltd.) Figure 8 Installing MCU to User Syste

Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang

Section 4 Verifying Operation 1. When using the E6000 emulator (HS2148EPI61H) for the H8S/2148, H8S/2138, H8S/2128 series, turn on the emulator acc

Section 5 Notice 1. Make sure that pin 1 on the user system IC socket is correctly aligned with pin 1 on the cable head before inserting the cable

H8S/2128Series QFP-64AUser System Interface Cable (HS2128ECH61H) for E6000 EmulatorUser’s ManualUser’s Manual

Cautions 1. Renesas neither warrants nor grants licenses of any rights of Renesas’s or any third party’s patent, copyright, trademark, or other intel

i Preface Thank you for purchasing this user system interface cable (HS2128ECH61H) for the Renesas’s original microcomputer H8S/2128 series. The HS21

ii Contents Section 1 Configuration...1 Section

1 Section 1 Configuration CAUTION Use an IC149-064-008-B5 socket (manufactured by YAMAICHI ELECTRONICS Co., Ltd.) for the FP-64A package

2 Screws (M2.0 x 12 mm)IC socketCable headUser systemSocket coverScrews (M2.0 x 8 mm)and flat washersand flat washers(For fastening cable head) Figu

3 Table 1 lists the HS2128ECH61H components. Please make sure you have all of these components when unpacking. Table 1 HS2128ECH61H Components No.