Renesas Emulation Pod M30100T3-RPD-E Manual de usuario descargar pdf (Pagina 32)

( 32 / 52 )

Chapter 4. Usage

4.1 Turning On the Power Supply

(1) Checking Connections of the Emulator System

Before turning the power ON, check the connections of the PC4701, emulation pod, pod probe,

converter board and target system.

(2) Turning On the Power

• Turn on the power of the emulator and target system as simultaneously as possible.

• Turn off the power of the emulator and target system as simultaneously as possible.

• Do not leave either the emulator or target system powered on, because of leakage current the

internal circuits may be damaged.

• When turning on the power again after shutting off the power, wait about 10 seconds.

CAUTION

Notes on Power Supply:

•The emulator's pin VCC is connected to the target system in order to monitor target

system voltage. For this reason, the emulator cannot supply power to the target

system. Therefore, provide the target system with a separate power supply from that

of the emulator.

• Keep target system power supply voltage within the MCU's specified range (2.7 to

5.5 V).

• Do not change target system power supply voltage after power has been activated.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Sin comentarios

Renesas Emulation Pod M30100T3-RPD-E Manual de usuario Pagina 32