Renesas Single-Chip Microcomputer M34551T2-MCU Manual de usuario descargar pdf (Pagina 23)

( 21 / 40 )

4.5 Connection to the Target System

When connecting the M34551T2-MCU board to the target system:

Connect the 50-wire normal-pitch cable included with the MCU board to the 50-pin dual-in-line pins

on the target system. Following products are required for connection to the target system.

(1) 100-wire half-pitch cable (40 cm)

(2) PCA4029 pitch converter board

(3) 50-wire normal-pitch cable (10 cm)

Figure 4.7 depicts the M34551T2-MCU board connected to the target system using the 50-wire

normal-pitch cable. Table 4.8 lists the connector signal assignments of the 50-wire normal-pitch

cable. Figure 4.8 shows the pin layout of the 50-wire normal-pitch cable.

Figure 4.7 Connecting the MCU board to the target system using dual-in-line pins

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Sin comentarios

Renesas Single-Chip Microcomputer M34551T2-MCU Manual de usuario Pagina 23