Renesas Single-Chip Microcomputer M37531T-ADS Manual de usuario descargar pdf (Pagina 10)

( 8 / 12 )

5.2 Using the CR Oscillator Circuit Pattern

There is a CR oscillator circuit pattern on the M37531T-ADS.

To use the CR oscillator circuit pattern, mount R3 and C5, and remove the coated wire of JP1, then

change the setting.

Figure 5.3 Using the CR oscillator circuit pattern

CAUTION

Note on Setting Up:

• Always shut OFF power before connecting this product. The power ON state could

destroy internal circuits.

As pins 5-6 and 2-3 of JP1 are shorted out by the coated

wire when shipped from the factory, use the oscillation of

OSC-2.

To use the CR oscillator circuit pattern, mount R3 and C5,

and remove the coated wire of JP1, then change the

setting as following.

When using CR oscillation: Short-circuit 4-5, 1-2

When using OSC-2: Short-circuit 5-6, 2-3

1 2 ... 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Renesas Single-Chip Microcomputer M37531T-ADS Manual de usuario Pagina 10