Renesas Emulation Pod for M30240 Group MCUs M30240T-RPD-E Información técnica descargar pdf (Pagina 29)

( 27 / 58 )

(2) Changing the Internal Oscillator Circuit of Emulation Pod

An oscillator circuit board for 12MHz is mounted on this product. To use the emulation pod at a

frequency lower than 12MHz, build the desired oscillator circuit on the included OSC-2 oscillator

circuit board (bare board) and replace the board installed in the emulation pod when shipped from

the factory.

Figure 3.5 shows a view of the OSC-2 oscillator circuit board (bare board) and where connector pins

are located. Figure 3.6 shows the circuitry of the OSC-2 oscillator circuit board (bare board). Use the

number of oscillator circuits recommended by the oscillator manufacturer.

Figure 3.5 External view of oscillator board (OSC-2) and connector pin assignment

J1-4: GND

J1-3: Oscillator output

J1-2: GND

J1-1: Vcc

Figure 3.6 Circuit of oscillator board (OSC-2)

* X1: 5.08-mm-pitch 2-pin oscillator IC1: Inverter (Unbuffer)

* X2: 2.54-mm-pitch 2-pin oscillator

* X3: 2.54-mm-pitch 3-pin oscillator

IC1

X1 ,X2

CLK

Vcc

GND

J1-3

1011 8

IC1

J1-1

J1-2

J1-4

GND

IC1

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Sin comentarios

Renesas Emulation Pod for M30240 Group MCUs M30240T-RPD-E Información técnica Pagina 29