Renesas HS2378KCI01H Información técnica

To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C

73. #RES of pin 4 of the Hitachi-UDI port connector is a signal line in which theemulator outputs signals to the MCU. An AND operation must be perfor

87. When H8S/2377F and H8S/2377RF are connected to the emulator, I/O functionsof P53 and PG4 to PG6 , and functions of #WDTOVF, #IRQ3, #ADTRG, #BREQ,

Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang

Regarding the change of names mentioned in the document, such as Hitachi Electric and Hitachi XX, to Renesas Technology Corp.The semiconductor operati

www.renesas-electoronics.comConnection of H8S/2377F and H8S/2377RFUser’s ManualUser’s ManualVersion 1.00HS2378KCM01HHS2378KCI01Hwith E10A Emulator

21. Connecting the E10A Emulator with the User systemBefore connecting an E10A emulator (here after referred to as emulator) with the user system, ac

32. Installation of Connector in the User SystemTable 2.1 shows the Hitachi-UDI port connector for the emulator.Table 2.1 Recommended ConnectorTyp

43. Pin Arrangement of the H-UDI Port ConnectorFigure 3.1 shows the pin arrangement of the Hitachi-UDI port connector.Figure 3.1 Pin Arrangement o

54. Example of Emulator ConnectionThe following shows an example of connecting the user system to the emulator.Figure 4.1 Example of Emulator Conne

6Notes: 1. #WDTOVF, P53, and PG4 to PG6 are used by the emulator for H8S/2377F andH8S/2377RF. Pull up and connect the emulator and MCU pins. Periphe