Renesas Emulator System E8 Información técnica descargar pdf (Pagina 11)

Section 2 Connecting the Emulator with the User System

Before connecting an E8/E8a emulator (hereafter referred to as emulator) with the user system, a

connector must be installed in the user system so that a user system interface cable can be

connected. When designing the user system, refer to the connector and recommended circuits

shown in this manual.

Before designing the user system, be sure to read the E8/E8a emulator user’s manual and the

hardware manual for related MCUs.

Table 2.1 shows the recommended connector for the emulator.

Table 2.1 Recommended Connector

Type Number Manufacturer Specifications

2514-6002 3M Limited 14-pin straight type

Connect pins 2, 4, 6, 10, 12, and 14 of the user system connector to GND firmly on the PCB.

These pins are used as electrical GND and to monitor the connection of the user system connector.

Note the pin assignments of the user system connector.

User system interface cable

User system connector

User system

Pin 1

Pin 2

Figure 2.1 Connecting the User System Interface Cable to the User System

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Sin comentarios

Renesas Emulator System E8 Información técnica Pagina 11