Renesas PC7501 Manual de usuario descargar pdf (Pagina 267)

11 Display the Cause of the Program Stoppage

257

11. Display the Cause of the Program Stoppage

If the program is stoped by the debug function, the cause of the stoppage is displayed in the Output

window or Status window ([Platform] sheet).

The contents of a display and the meaning of "the cause of the stoppage" are as follows.

Disp y

The cause of the stoppage

Halt The stop by the [Halt Program] button/menu

S/W break Software break

Address match interrupt break Address interrupt break

H/W event, Combination Hardware break, logical combination AND or AND(same

time)condition was met

H/W event, Combination, Ax Hardware break, logical combination OR condition was

met

(Ax: The event number of which condition was met.)

H/W event, State transition, from xx Hardware break, State Transition condition was met

(from xx: previous state (start, state1, state2))

H/W event, State transition, Timeout Hardware break, State Transition, Time Out condition was

met

H/W event, Access protect error Protect break

Note

To be able to show the cause of break or not depends on the connected target. Some targets may

always show "Halt" or show "---".

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 285 286

Sin comentarios

Renesas PC7501 Manual de usuario Pagina 267