Renesas HS6400FDIW3S Manual de usuario descargar pdf (Pagina 74)

6.5.3 Device Tab

This shows the device information. It also allows the user to select BOOT Mode or USER Program

Mode and the ‘Direct Connection’ interface. In addition, it can specify whether or not the kernel is in

the target device.

Figure 6-10 Device Properties

Device

Displays the name of the active device. Double clicking invokes the Project Wizard to allow

editing of this item.

RAM Size, FLASH Size, Flash Start

These are for display only and are not editable.

Connection

Boot Mode: This connection type specifies that the on-board programming BOOT mode

sequence is to be initiated. This will cause the entire FLASH memory to be erased and a

kernel loaded.

USER (Program) Mode: This connection type specifies that the on-board programming

USER Program mode sequence is to be initiated by a previously loaded user program that is

used to reprogram the FLASH memory.

Interface

If the target is connected directly to the host computer, the connection interface should be

selected to ‘Direct Connection’. Alternative options include FDM and for Protocol A (legacy)

kernels, the UPB.

Double clicking invokes the Project Wizard to allow editing of this item.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 93 94

Sin comentarios

Renesas HS6400FDIW3S Manual de usuario Pagina 74