Renesas H8S/2128 Series Información técnica descargar pdf (Pagina 34)

5.2 Diagnostic Test Procedure Using the Test Program

Insert the CD-R (HS2148EPI61SR supplied with the E6000) into CD-ROM drive of the host

computer by pressing the Shift key, move the current directory to <Drive>:¥Diag with a command

prompt, and enter one of the following commands according to the PC interface board used to

initiate the test program:

1. ISA bus interface boad (HS6000EII01H)

>TM2148 ISA (RET)

2. PCI bus interface boad (HS6000EIC01H, HS6000EIC02H)

>TM2148 PCI (RET)

3. PCMCIA interface card (HS6000EIP01H)

>TM2148 PCCD (RET)

Be sure to initiate the test program from <Drive>:¥Diag. Do not initiate it from a directory other

than <Drive>:¥Diag, such as <Drive>:¥Diag¥TM2148 ISA (RET). If the test program is

initiated when the current directory is not <Drive>:¥Diag, the test program will not operate

correctly.

When S is added to the command line such as >TM2148 ISA S (RET), steps 1 to 18 will be

repeatedly executed. To stop the execution, enter Q.

Notes: 1. When the CD-R is inserted into the CD-ROM drive without pressing the Shift key, the

HDI installation wizard is automatically started.

2. <Drive> is a drive name for the CD-ROM drive.

3. Do not remove the CD-R from the CD-ROM drive during text program execution.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39

Sin comentarios

Renesas H8S/2128 Series Información técnica Pagina 34