Renesas H8S/2338 Series Información técnica descargar pdf (Pagina 31)

5.2

5.25.2

5.2 Diagnostic Test Procedure Using Tes

Diagnostic Test Procedure Using TesDiagnostic Test Procedure Using Tes

Diagnostic Test Procedure Using Test Program

t Programt Program

t Program

Insert the CD-R (HS2339EPI61SR supplied with the E6000) into the CD-ROM drive of the host

computer by pressing the Shift key, move the current directory to <Drive>:\Diag with a command

prompt, and enter one of the following commands according to the PC interface board used to

initiate the test program:

1. ISA bus interface board (HS6000EII01H)

>TM2339 ISA (RET)

2. PCI bus interface board (HS6000EIC01H, HS6000EIC02H)

>TM2339 PCI (RET)

3. PCMCIA interface card (HS6000EIP01H)

>TM2339 PCCD (RET)

The HDI must be installed before the test program is executed.

Be sure to initiate the test program from <Drive>:\Diag. Do not initiate it from a directory other

than <Drive>:\Diag, such as > <Drive>:\Diag\TM2339 ISA (RET). If the test program is

initiated when the current directory is not <Drive>:\Diag, the test program will not operate

correctly.

When S is added to the command line such as >TM2339 ISA S (RET), steps 1 to 18 will be

repeatedly executed. To stop the execution, enter Q.

Notes: 1. When the CD-R is inserted into the CD-ROM drive without pressing the Shift key, the

HDI installation wizard is automatically started.

In such a case, exit the HDI installation wizard.

2. <Drive> is a drive name for the CD-ROM drive.

3. Do not remove the CD-R from the CD-ROM drive during test program execution.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Renesas H8S/2338 Series Información técnica Pagina 31