Renesas H8S/2615 Series Información técnica descargar pdf (Pagina 27)

5.2 Diagnostic Test Procedure Using the Test Program

Insert the CD-R (HS2628EPI61SR supplied with the E6000) into the CD-ROM drive of the host

computer by pressing the Shift key, move the current directory to <Drive>:\Diag with a command

prompt, and enter one of the following commands according to the PC interface board used to initiate

the test program:

1. PCI bus interface board (HS6000EIC01H or HS6000EIC02H)

> TM2628

–

PCI (RET)

2. PCMCIA interface card (HS6000EIP01H)

> TM2628

–

PCCD (RET)

3. USB adapter (HS6000EIU01H)

> TM2628

–

USB

4. LAN adapter (HS6000ELN01H)

> TM2628

–

ELN

The HDI must be installed before the test program is executed.

Be sure to initiate the test program from <Drive>:\Diag. Do not initiate it from a directory other than

<Drive>:\Diag, such as > <Drive>:\Diag\TM2628

–PCI

(RET). If the test program is initiated when the

current directory is not <Drive>:\Diag, the test program will not operate correctly.

When

–

S is added to the command line such as > TM2628

–

PCI

–

S (RET), steps 1 to 19 will be

repeatedly executed. To stop the execution, enter Q.

Notes: 1. When the CD-R is inserted into the CD-ROM drive without pressing the Shift key, the HDI

installation wizard is automatically started.

In such a case, exit the HDI installation wizard.

2. <Drive> is a drive name for the CD-ROM drive.

3. Do not remove the CD-R from the CD-ROM drive during test program execution.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Sin comentarios

Renesas H8S/2615 Series Información técnica Pagina 27