Renesas H8/3257 Series Manual de usuario

To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C

Figure 2 Connecting User System Interface Cable to Emulator Station 2.2 Connecting User System Interface Cable to User System WARNING Always s

5 2.2.2 Soldering IC Socket After fastening, solder the IC socket for an FP-64A package to the user system. Be sure to completely solder the leads

Screws (M2.0 x 12 mm)and flat washersCable headPin 1IC socket(IC149-064-008-B5manufactured by YAMAICHI ELECTRONICS Co., Ltd.)User system Figure 3 Co

2.2.5 Fastening Cable Body Connect the cable body to the cable head. Cable bodyCable headUnfastening jigPush the unfastening jigRemovingUser systemF

2.3 Recommended Dimensions for User System Mount Pad Figure 5 shows the recommended dimensions for the mount pad (footprint) for the user system with

2.4 Dimensions for User System Interface Cable Head The dimensions for the user system interface cable head are shown in figure 6. Figure 6 Dime

2.5 Resulting Dimensions after Connecting User System Interface Cable The resulting dimensions, after connecting the user system interface cable head

11 Section 3 Installing the MCU to the User System CAUTION 1. Check the location of pin 1 before inserting. 2. Use a Phillips-type screwdrive

MCUPin 1 markUser systemSocket coverIC socket (IC149-064-008-B5manufactured by YAMAICHI ELECTRONICS Co., Ltd.) Figure 8 Installing MCU to User Syste

Section 4 Verifying Operation 1. When using the H8/300 series E6000 emulator (HS3008EPI60H), turn on the emulator according to the procedures descr

Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang

Section 5 Notice 1. Make sure that pin 1 on the user system IC socket is correctly aligned with pin 1 on the cable head before inserting the cable

H8/3257 Series, H8/325 Series FP-64AUser System Interface Cable (HS3257ECH61H) for E6000 EmulatorUser’s ManualUser’s ManualRev.3.0 2003.04

Cautions 1. Renesas neither warrants nor grants licenses of any rights of Renesas’s or any third party’s patent, copyright, trademark, or other intel

i Preface Thank you for purchasing the E6000 emulator for the Renesas’s original microprocessor H8/300 series. The HS3257ECH61H is a user system inte

ii Contents Section 1 Configuration...1 Section 2 Connection Pr

Section 1 Configuration CAUTION Use an IC149-064-008-B5 socket (manufactured by YAMAICHI ELECTRONICS Co., Ltd.) for the FP-64A package IC

2 Table 1 lists the HS3257ECH61H components. Please make sure you have all of these components when unpacking. Table 1 HS3257ECH61H Components No.

Section 2 Connection Procedures 2.1 Connecting User System Interface Cable to Emulator Station WARNING Observe the precautions listed below. F