Renesas Single-Chip Microcomputer M306NKT3 Manual de usuario descargar pdf (Pagina 136)

120

Figure 13-2 E8Direct enumeration

13.2 Hardware Differences

The FDM had no capability of supplying the target power whereas the E8Direct can supply 3.3V or 5V and the

FDM-E8Direct pin usage is different. This means that it is not possible to simply swap an FDM for an E8. The

general purpose I/O pins on the FDM were labelled as MD0 to MD4 and FWE, and they had a direct mapping

with the mode pins with matching names on the target devices. Because the number of available general purpose

I/O pins is reduced on the E8, and the locations on the 14-pin header are different, we can no longer have a

direct mapping between device mode pin names and E8 I/O pins, so we have chosen to label them as ‘A’, ‘B’,

‘C’ and ‘D’. The pin settings required for E8Direct will have to be board specific rather than device specific.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 146 147

Sin comentarios

Renesas Single-Chip Microcomputer M306NKT3 Manual de usuario Pagina 136