Renesas SH7641 Información técnica descargar pdf (Pagina 232)

210

In the [Configuration] dialog box, if [User] is set while the [UBC mode] list box has been set, the

STEP-type commands that use Break Condition 2 for implementation cannot be used. If these

commands are used, the message box shown in figure 6.14 is displayed.

Figure 6.14 [HDI] Message Box

6.5.9 Performance Measurement Function

The SH7641 E10A emulator supports the performance measurement function.

1. Setting the performance measurement conditions

To set the performance measurement conditions, use the [Performance 1] dialog box and the

PERFORMANCE_SET command. When the right mouse button is clicked on the

[Performance Analysis] window, the popup menu is displayed and the [Performance 1] dialog

box is displayed by selecting [Setting].

Note: For the command line syntax, refer to the online help.

 Specifying the measurement start/end conditions

The measurement start/end conditions are specified in the [Mode] drop-down list box in

the [Performance 1] dialog box. Three conditions can be set as shown in table 6.11.

Table 6.11 Conditions Specified in [Mode]

Item Description

Normal break Measurement is started by executing a program and ended when a

break condition is satisfied.

Break Condition 1 -> 2 Measurement is started from the satisfaction of the condition set in

Break Condition 1 and ended with the satisfaction of the condition set

in Break Condition 2.

Break Condition 2 -> 1 Measurement is started from the satisfaction of the condition set in

Break Condition 2 and ended with the satisfaction of the condition set

in Break Condition 1.

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 249 250

Sin comentarios

Renesas SH7641 Información técnica Pagina 232