Renesas Emulation Pod for M16C/80 Group MCUs M30803T-RPD-E Información técnica descargar pdf (Pagina 44)

( 42 / 74 )

(6) Connecting 100-pin 0.5-mm-pitch Foot Pattern (Part 2)

Figure 3.17 shows how to connect the emulation pod probe to the 100-pin 0.5-mm-pitch foot pattern

on the target system with the FLX-100NSD (not included), and here following is its procedure. For

details on the 100LCC-DMS and FLX-100NSD, refer to each user's manual.

(1) Attach the FLX-100NSD to the target system.

For details on how to attach the FLX-100NSD to the target system, see the user's manual of

FLX-100NSD.

(2) Attach the 100LCC-DMS to the FLX-100NSD.

(3) Attach the M30800T-PTC to the FLX160-PRB.

(4) Attach the M30800T-PTC to the 100LCC-DMS.

Figure 3.17 Connecting emulation pod probe and 100-pin 0.5-mm-pitch foot pattern (part 2)

CAUTION

Notes on Connecting the Target System:

• Take care not to attach the converter board in a wrong direction. It may cause a fatal

damage to the emulation pod.

• The small connectors of 100LCC-DMS and FLX-100NSD are guaranteed for only

20 insertion/removal iterations.

• The small connectors of M30800T-PTC are guaranteed for only 50 insertion/

removal iterations.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

Sin comentarios

Renesas Emulation Pod for M16C/80 Group MCUs M30803T-RPD-E Información técnica Pagina 44