Renesas Emulation Probe for M32C/88 Group M30880T-EPB Información técnica descargar pdf (Pagina 33)

M30880T-EPB User’s Manual 2. Setup

REJ10J0497-0100Z Rev.1.00 January 16, 2005 Page 31 of 100

2.9.2 Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 1)

Figure 2.9 shows how to connect the emulation probe to a 100-pin 0.65-mm-pitch foot pattern on the user system with the

M3T-DUMMY100S (not included), and here following is its procedure.

For details on the M3T-100LCC-DMS and M3T-DUMMY100S, refer to each user's manual.

(1) Attach the M3T-DUMMY100S to the user system.

(2) Attach the M3T-100LCC-DMS to the M3T-DUMMY100S.

(3) Attach the M30800T-PTC to the M30880T-EPB.

(4) Attach the M30800T-PTC to the M3T-100LCC-DMS.

M3T-100LCC-DMS

(not included)

M3T-FLX160-EPB

M30880T-EPB

CN2 side

(3)

(4)

M30800T-PTC

(2)

FLASH MCU etc.

On-board evaluation

M3T-DUMMY100S

(not included)

(1)

100-pin 0.65-mm-pitch

(100P6S) foot pattern

No. 1 pin

User system

Figure 2.9 Connecting to a 100-pin 0.65-mm-pitch foot pattern (1/3)

CAUTION

Notes on Connecting the User System:

 Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator.

 The small connectors of the M3T-100LCC-DMS and M3T-DUMMY100S are guaranteed for only 20

insertion/removal iterations.

 The small connectors of the M30880T-EPB and M30800T-PTC are guaranteed for only 50 insertion/removal

iterations.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 101 102

Sin comentarios

Renesas Emulation Probe for M32C/88 Group M30880T-EPB Información técnica Pagina 33