Renesas Emulator System E8 Guía de usuario descargar pdf (Pagina 21)

CSE8E10-2

Introduction to C-SPY® hardware debugger systems

to save time. For information on how to set this behavior in C-SPY, see the option Do

not show this dialog box again, page 6. If you set this option, the connection to the

hardware is maintained and the initialization is not repeated. This option is mirrored in

the menu command Show Emulator Setting, see the The Emulator menu, page 17.

Connecting to the target board, E10A-USB

To establish a connection to the target board, follow this procedure:

1 To select the device that matches your target system, choose

Project>Options>General Options>Target in IAR Embedded Workbench.

2 Select the driver that matches your emulator on the

Project>Options>Debugger>Setup page.

3 Build the project if it has not been built and choose Project>Debug to start C-SPY.

4 The Select Emulator mode dialog box is displayed.

Figure 7: The Select Emulator mode dialog box for the E10A-USB emulator

Select the device name in use from the Device drop-down list. The following items can

be selected in the Mode group box.

E10A-USB Emulator Description

E10A-USB Emulator The E10A-USB emulator for the specified device is activated.

Debugging the program is enabled.

Program Flash Your application is programmed to the internal flash memory.

Debugging the program is disabled.

Table 5: The E10A-USB emulator mode options

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 40 41

Sin comentarios

Renesas Emulator System E8 Guía de usuario Pagina 21