Renesas Emulator System E8 Guía de usuario descargar pdf (Pagina 37)

CSE8E10-2

Hardware-specific debugging

● Check that you are using correct linker command file.

If you are using the IAR Embedded Workbench, the linker command file is

automatically selected based on your choice of device:

● Choose Project>Options

● Select the General Options category

● Click the Target tab

● Choose the appropriate device from the Device drop-down menu.

To override the default linker command file:

● Choose Project>Options

● Select the Linker category

● Click the Config tab

● Choose the appropriate linker command file in the Linker command file area.

NO CONTACT WITH THE TARGET HARDWARE

There are several possible reasons for C-SPY to fail to establish contact with the target

hardware.

● Check the communication devices on your host computer

● Verify that the cable is properly plugged in and not damaged or of the wrong type

● Verify that the target chip is properly mounted on the evaluation board

● Make sure that the evaluation board is supplied with sufficient power

● Check that the correct options for communication have been specified in the IAR

Embedded Workbench; see the documentation provided with the target system.

Examine the linker command file to make sure that your application has not been linked

to the wrong address.

1 2 ... 32 33 34 35 36 37 38 39 40 41

Sin comentarios

Renesas Emulator System E8 Guía de usuario Pagina 37