Renesas H8S/2378F Información técnica descargar pdf (Pagina 65)

Set the pins on the adapter board (FDM) for the user boot mode.

For example, set the output of FWx to high (1) and that of MD2 to low (0).

In this example, the FWx pin outputs 1 for selecting a mode (the jumper is open) and MD2 (IO0) outputs 0 for serial

communication connection.

Turn the power off and select the user boot mode (mode 5) using DIP switch 6. When you have set the pins, turn on the

power.

Table 4-6 Operating Mode Setting

Jumper FWE MD2 MD1 MD0 SCI Switch MCU

Operating

Mode

CPU Operating

Mode

J15 FWx (Pin 3) on

the Adapter

Board

SW6-3 SW6-2 SW6-1 MD2 (Pin 9) on

the Adapter

Board

5 User boot mode 1 (Open) 1 (Output 1) 1 (OFF) 0 (ON) 1 (OFF) 0 (Output 0)

When you have set the items, click "Finish."

Note: Do not operate the mode switch during CPU operation. Be sure to operate the FWE and MD pins after turning the

power to the board off or while pressing the RESET button.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 108 109

Sin comentarios

Renesas H8S/2378F Información técnica Pagina 65