Renesas H8S/2378F Información técnica descargar pdf (Pagina 81)

5. Flash Development Toolkit Processing

The Flash Development Toolkit can be connected in either of the following two modes: the boot mode or the user

program mode. In both modes, the continuation of the execution from a previous session can be specified. The

connection modes of the Flash Development Toolkit are listed in

Table 5-1. Normally, a new connection processing is

used. The hexadecimal code is a command code of the Flash Development Toolkit. For details, refer to the description

on flash memory (0.18-μm F-ZTAT version) in the Hardware Manual.

Table 5-1 Connection Modes of the Flash Development Toolkit

Mode New Connection Processing Continuation of the Execution from a Previous

Session

Boot mode Baud rate adjustment

H'27 (Programming unit inquiry)

H'10 (Device selection)

H'11 (Clock mode selection)

H'3F (New baud rate setting)

H'27 (Programming unit inquiry)

H'4F (Status request)

H'4D (User area blank check)

User boot mode

User program mode

H'27 (Programming unit inquiry)

H'10 (Device selection)

H'11 (Clock mode selection)

H'3F (New baud rate setting)

H'27 (Programming unit inquiry)

H'4F (Status request)

H'4D (User area blank check)

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 108 109

Sin comentarios

Renesas H8S/2378F Información técnica Pagina 81