
E8a Emulator Section 6 Notes on Using the E8a Emulator
Section 6 Notes on Using the E8a Emulator
1. Program area for the E8a emulator
Table 6.1 lists the program areas allotted for the E8a emulator. Do not change this area allocation, otherwise the
E8a emulator will not control the MCU. If settings were changed, disconnect the debugger and then reconnect it.
Table 6.1 Program Area for the E8a Emulator
ROM Size Program Area for E8a Emulator
Group Part No.
Programming
Area
Data Area
RAM Size
Vector Area ROM Area RAM Area
M30302FAP 96 KB 5 KB
M30302FCP 128 KB 5 KB
M30302FEP 192 KB
4 KB
6 KB
M3030RFAP 96 KB 5 KB
M3030RFCP 128 KB 5 KB
M3030RFDP 160 KB 6 KB
M3030SFDP 160 KB 12 KB
M3030RFEP 192 KB 6 KB
M3030SFEP 192 KB 12 KB
M16C/30P
M3030RFGP 256 KB
-
12 KB
FFFE4h - FFFE7h,
FFFE8h - FFFEBh,
FFFECh - FFFEFh,
FFFF4h - FFFF7h,
FFFFCh - FFFFFh
2 KB of the
programming
area [*1]
128 bytes
[*1]
Note:
1. When starting the debugger, the [Emulator Setting] dialog box shown in Figure 6.1 is displayed. Specify the area which will not
be used in the user system. The data area cannot be specified.
Figure 6.1 [Firmware Location] Tab of the [Emulator Setting] Dialog Box
REJ10J1639-0500
Rev.5.00 Page 10 of 23
Apr.30.10
Comentarios a estos manuales