Renesas Single-Chip Microcomputer M38C89T-ADF Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 82
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
M38000T2-CPE User’s Manual 2. Setup
R20UT0213EJ0600 Rev.6.00 Page 26 of 82
Oct. 20, 2010
2.6.2 Connecting the Emulator MCU
There are two ways available to connect the emulator MCU and M38000T2-CPE according to the emulator MCU type.
(1) For RSS and RLSS Type Emulator MCU
When the emulator MCU is RSS or RLSS type, connect the tip probe M38000T2-CPEC of the M38000T2-CPE emulator to
the emulator MCU directly. To connect them, align the No. 1 pins.
(2) For RFS and RLFS Type Emulator MCU
When the emulator MCU is RFS or RLFS type, connect the converter board PCA4933 (included) between the tip probe
M38000T2-CPEC of the M38000T2-CPE emulator and the emulator MCU. To connect them, align the No. 1 pins.
User system
User system
Emulator probe
Emulator probe
No.1 pin
Bevel-edged and marked
No.1 pin
Bevel-edged and marked
No.1 pin
Bevel-edged
No.1 pin
Emulator MCU
(RSS/RLSS type)
Emulator MCU
(RFS/RLFS type)
No.1 pin
Converter board
PCA4933
Converter board
(separately available)
Converter board
(separately available)
When the emulator MCU is RSS or RLSS type.
When the emulator MCU is RFS or RLFS type.
Figure 2.7 Connecting the emulator and emulator MCU
CAUTION
Notes on Connecting Emulator MCU:
Always shut OFF the emulator and the user system when connecting and disconnecting the user system.
Otherwise the internal circuit may cause a break.
Take care not to attaché the converter board in a wrong direction. It may cause a fatal damage to the compact
emulator.
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 81 82

Comentarios a estos manuales

Sin comentarios