Renesas SuperH SH7200 Series Manual de usuario descargar pdf (Pagina 32)

Table 2.10 Conditions to Be Set (cont)

Classification Item Description

[Ch4, 5] list box Setting is disabled in this MCU.

Don’t care [Don’t care] is fixed in this MCU.

I-Trace: Ch5 to Ch4

PtoP

Setting is disabled in this MCU.

I-Trace: Ch5 to Ch4

PtoP, power-on reset

Setting is disabled in this MCU.

Notes: 1. After the sequential condition and the count specification condition of Event Condition 1

have been set, a break will be halted if the sequential condition is satisfied for the

specified count.

2. If a reset point is satisfied, the satisfaction of the condition set in Event Condition will be

disabled. For example, if the condition is satisfied in the order of Event Condition 3, 2,

reset point, 1, a break will not be halted. If the condition is satisfied in the order of Event

Condition 3, 2, reset point, 3, 2, 1, the break will be halted.

3. If the start condition is satisfied after the end condition has been satisfied by measuring

performance, performance measurement will be restarted. For the measurement result

after a break, the measurement results during performance measurement are added.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Sin comentarios

Renesas SuperH SH7200 Series Manual de usuario Pagina 32