Renesas SuperH SH7343 Información técnica descargar pdf (Pagina 44)

2.2.5 Notes on Setting the [Event Condition] Dialog Box and the BREAKCONDITION_

SET Command

1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Event

Condition 3 are disabled.

2. When an Event Condition is satisfied, emulation may stop after two or more instructions have

been executed.

3. If a PC break address condition is set to the slot instruction after a delayed branch instruction,

user program execution cannot be terminated before the slot instruction execution; execution

stops before the branch destination instruction.

2.2.6 Note on Setting the UBC_MODE Command

In the [Configuration] dialog box, if [User] is set while the [UBC mode] list box has been set,

Ch10 (IA_OA_R) and Ch11 (OA_OA_CT_R) of Event Condition cannot be used.

2.2.7 Note on Setting the PPC_MODE Command

In the [Configuration] dialog box, if [User] is set while the [PPC mode] list box has been set, Ch1

and Ch2 of the performance analysis function and options 1 and 2 of the profile function cannot be

used.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 58 59

Sin comentarios

Renesas SuperH SH7343 Información técnica Pagina 44