Renesas User System Interface Cable HS2655ECH61H Información técnica descargar pdf (Pagina 28)

5.2 Diagnostic Test Procedure Using the Test Program

Insert the CD-R (HS2655EPI61SR supplied with the E6000) into the CD-ROM drive of the host

computer by pressing the Shift key, move the current directory to <Drive>:\Diag with a command

prompt, and enter one of the following commands according to the PC interface board used to

initiate the test program:

1. ISA bus interface boad (HS6000EII01H)

> TM2655



ISA (RET)

2. PCI bus interface boad (HS6000EIC01H or HS6000EIC02H)

> TM2655



PCI (RET)

3. PCMCIA interface card (HS6000EIP01H)

> TM2655



PCCD (RET)

The HDI must be installed before the test program is executed.

Be sure to initiate the test program from <Drive>:\Diag. Do not initiate it from a directory other

than <Drive>:\Diag, such as > <Drive>:\Diag\TM2655



ISA (RET). If the test program is

initiated when the current directory is not <Drive>:\Diag, the test program will not operate

correctly.

When



S is added to the command line such as >TM2655



ISA



S (RET), steps 1 to 18 will be

repeatedly executed. To stop the execution, enter Q.

Notes: 1. When the CD-R is inserted into the CD-ROM drive without pressing the Shift key, the

HDI installation wizard is automatically started.

In such a case, exit the HDI installation wizard.

<Drive> is a drive name for the CD-ROM drive.

Do not remove the CD-R from the CD-ROM drive during test program execution.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Sin comentarios

Renesas User System Interface Cable HS2655ECH61H Información técnica Pagina 28