Renesas H8SX/1668R Información técnica descargar pdf (Pagina 7)

Chapter 3. Power Supply

3.1. Requirements

This RSK operates from a 5V power supply.

A diode provides reverse polarity protection only if a current limiting power supply is used.

All RSK boards are supplied with an E10A debugger.

All RSK boards have an optional centre positive supply connector using a 2.0mm barrel power jack.

Warning

The RSK is neither under nor over voltage protected. Use a centre positive supply for this board.

3.2. Power – Up Behaviour

When the RSK is purchased the RSK board has the ‘Release’ or stand alone code from the example tutorial code pre-programmed into the

Renesas microcontroller. On powering up the board the user LEDs will start to flash. After 200 flashes, or after pressing a switch the LEDs

will flash at a rate controlled by the potentiometer.

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Sin comentarios

Renesas H8SX/1668R Información técnica Pagina 7