Renesas Emulation Pod M3062PT3-RPD-E Información técnica descargar pdf (Pagina 39)

( 37 / 76 )

Figure 3.8 Position for mounting pullup resistors

3.5 Installing and Removing Pullup Resistors

In this product, you cannot control pullup for ports P0 to P5 by pullup control registers (pullup control

Mounting a pullup resistor inside this product allows pullup control. Mount the 51kΩ resistor array

supplied with this product to the port for which pullup control is required. For the mounting location,

refer to Figure 3.8 below.

CAUTION

Note on Installing and Removing Pullup Resistors:

• Always shut OFF power before installing or removing pullup resistors. Otherwise,

the internal circuits may be damaged.

• Install pullup resistors properly. Otherwise, the emulation pod will be damaged.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 77 78

Sin comentarios

Renesas Emulation Pod M3062PT3-RPD-E Información técnica Pagina 39