R32C/100 E30A Emulator Debugger Release Notes
REJ10J2119-0100 Rev.1.00 Page 4 of 9
Dec 01, 2010
1.13 Debugging for assembler macros
When the break points are set at the assembler macro codes, the break points would be set at the different address or
not be displayed as the PC line.
1.14 The option “Always treat variables of enumerator type with unknown size as 1
byte”
The “Always treat variables of enumerator type with unknown size as 1 byte” option is effective after downloading the
program. When the option status is changed, target program should be downloaded again.
And also, this option is effective for all variables of enumerator type in the program, even if the compiling options are
different for each file.
1.15 Debugging for inline functions
When stepping the function including the call for a inline function, local variables would not be able to be referred.
1.16 Automatic target connection on changing the session
When the target connection is not performed on changing the session, select the menu [Debug] -> [Connect]. To
perform automatic target connection, remove the check from the option “Do not perform automatic target connection”
in the Option tab on Debug Setting dialog box which is invoked by the menu [Debug] -> [Debug Settings…].
1.17 Run program option
The “Run Program” dialog box enables to specify several temporary PC breakpoints, but this debugger only supports
one breakpoint which is listed first in the “Temporary PC breakpoints” list box.
1.18 Selection of the object format for download module
When the specified file format in the debug setting dialog box is different from the format of the object module file,
downloading the file may cause a freeze of the debugger. Please select the correct object format. And also, when
selecting the object format for download module file, if there are two or more object format, whose name includes the
vender name another ones do not include it, prioritize the file whose name includes vender name leading the object
format name.
1.19 Break function
When the execution of the target program halts by the breakpoint, the debugger might not change the display to the halt
condition. In this case, please push the Halt Program button.
This problem occurs when the debugger started on the following conditions.
• When the Trace mode is selected in the Mode tab of the Init dialog, and the Trace Execution is selected in the
Trace Mode of the Event Setting window.
• When you set the condition branch trace.
• When the Time Measurement mode is selected in the Mode tab of the Init dialog, and the Time Measurement event
is used.
The debugger might not change the display to the halt condition because the following debugging functions use the
break function. In this case, please push the STOP button of the Running dialog.
• Go To Cursor
• Step Over
• Step Out
• Run…
• Run to main function on reset
(16 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales