Renesas User System Interface Board HS1650ECN61H Información técnica

To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C

i Preface The HS1650ECN61H is a user system interface board that connects a user system for the H8SX/1650 Series TFP-120 package to the H8SX/1650 Ser

ii Contents Section 1 Configuration...1 Section 2 Connection P

1 Section 1 Configuration Figure 1 and table 1 show the configuration and components of the user system interface board for the TFP-120 package. P

2 CAUTION Use an IC149-120-043-B51 socket (manufactured by YAMAICHI ELECTRONICS Co., Ltd.) for the TFP-120 package IC socket on the user sy

3 Section 2 Connection Procedures 2.1 Connecting User System Interface Board to User System WARNING Always switch OFF the user system and the

4 2.1.3 Installing IC Socket CAUTION Check the location of pin 1 before inserting. After checking the location of pin 1 on the user system inter

5 BoardUser systemPin 1Screws (M2 × 12 mm)with flat washers (for fastening cable head)IC socket (IC149-120-043-B51manufactured by YAMAICHI ELECTRONIC

6 2.2 Exchanging the Spacer of the EV-Chip Board While the user system interface board is connected to the user system, be careful not to apply load

7 2.3 Connecting User System Interface Board to EV-Chip Board WARNING Observe the precautions listed below. Failure to do so will result in

8 Connector No.UCN1 UCN1UCN2 UCN2BoardEV-Chip Board Connector No.Board Connector No.EV-chip board Figure 4 Connecting User System Interface Board t

Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang

9 2.4 Recommended Dimensions for User System Mount Pad (Footprint) Figure 5 shows the recommended dimensions for the mount pad (footprint) for the u

10 2.5 Dimensions for EV-Chip Board and User System Interface Board The dimensions for the EV-chip board and the user system interface board are sho

11 2.6 Resulting Dimensions after Connecting User System Interface Board The resulting dimensions, after connecting the user system interface board

12 Section 3 Verifying Operation 1. Turn on the emulator according to the procedures described in the H8SX/1650 Series E6000H Emulator User's

13  To use the crystal oscillator mounted on the EV-chip board Install the crystal oscillator into the crystal oscillator terminals on the EV-chip

14 Section 4 Notice 1. Before connecting any parts or cables, make sure that pin 1 on the both sides are correctly aligned. 2. Do not apply exces

H8SX/1650 Series E6000H TFP-120 User System Interface Board User's ManualPublication Date: Rev.3.00, Octo

1753, Shimonumabe, Nakahara-ku, Kawasaki-shi, Kanagawa 211-8668 JapanH8SX/1650 Series E6000H TFP-120User System Interface BoardREJ10B0048-0300HUser’s

H8SX/1650 Series E6000H TFP-120User System Interface BoardUser’s Manual HS1650ECN61HUser’s Manual Rev.3.0 2003.10

Cautions Keep safety first in your circuit designs! 1. Renesas Technology Corp. puts the maximum effort into making semiconductor products better an

I IMPORTANT INFORMATION READ FIRST • READ this user's manual before using this user system interface board. • KEEP the user's manual handy

II LIMITED WARRANTY Renesas warrants its user system interface boards to be manufactured in accordance with published specifications and f

III State Law: Some states do not allow the exclusion or limitation of implied warranties or liability for incidental or consequential damages,

IV SAFETY PAGE READ FIRST • READ this user's manual before using this user system interface board. • KEEP the user's manual handy for futur

V WARNING Observe the precautions listed below. Failure to do so will result in a FIRE HAZARD and will damage the user system and the emul