
53
38C3 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
GZZ-SH52-96B<85A0>
Receipt
740 FAMILY MASK ROM CONFIRMATION FORM
SINGLE-CHIP MICROCOMPUTER M38C34M6MXXXFP
MITSUBISHI ELECTRIC
Mask ROM number
Date:
Section head
signature
Supervisor
signature
Company
name
Note : Please fill in all items marked ❈.
Customer
❈
Issuance
signature
Date
issued
Submitted by
TEL
()
Date:
Supervisor
❈ 1. Confirmation
Specify the name of the product being ordered and the type of EPROMs submitted.
Three EPROMs are required for each pattern.
If at least two of the three sets of EPROMs submitted contain identical data, we will produce masks based on this data. We
shall assume the responsibility for errors only if the mask ROM data on the products we produce differs from this data.
Thus, extreme care must be taken to verify the data in the submitted EPROMs.
Checksum code for entire EPROM (hexadecimal notation)
In the address space of the microcomputer,
the internal ROM area is from address A08016
to FFFD16. The reset vector is stored in
addresses FFFC
16 and FFFD16.
(1) Set the data in the unused area (the shaded area of the
diagram) to “FF
16”.
(2) The ASCII codes of the product name “M38C34M6M” must
be entered in addresses 0000
16 to 000816. And set data
“FF
16” in addresses 000916 to 000F16. The ASCII codes
and addresses are listed to the right in hesadecimal
notation.
EPROM type (indicate the type used)
27256 27512
000016
000F16
001016
207F16
208016
7FFD16
7FFE16
7FFF16
EPROM address EPROM address
Product name
ASCII code :
‘M38C34M6M’
Data
ROM 24K-130 bytes
000016
000F16
001016
A07F16
A08016
FFFD16
FFFE16
FFFF16
Product name
ASCII code :
‘M38C34M6M’
Data
ROM 24K-130 bytes
(1/2)
Address
0000
16
000116
000216
000316
000416
000516
000616
000716
‘M’ = 4D16
‘3’ = 3316
‘8’ = 3816
‘C’ = 4316
‘3’ = 3316
‘4’ = 3416
‘M’ = 4D16
‘6’ = 3616
Address
0008
16
000916
000A16
000B16
000C16
000D16
000E16
000F16
‘ M ’ =4D16
FF16
FF16
FF16
FF16
FF16
FF16
FF16
Comentarios a estos manuales