Renesas Single-Chip Microcomputer SH7203 Información técnica descargar pdf (Pagina 23)

Chapter 8. Programming Methods

The RSK+SH7203 board can be programmed using E10A-lite supplied with the kit. Following headers are provided to download and

debug the user code – H-UDI and AUD.

8.1. H-UDI Header for E10A

This is a 14 pin header used to download and debug the user program. This header provides H-UDI interface for user debugging. Limited

Event conditions in ROM and unlimited Breakpoints in RAM are supported. The AUD trace function is not supported. Since the 14-pin type

connector is smaller than the 36-pin type (1/2.5), the area where the connector is installed on the user system can be reduced.

8.2. AUD Header for E10A

This is a 36 pin header used to download and debug the user program. This header provides additional AUD trace functions for user

debugging. A large amount of trace information can be acquired in realtime. The window trace function is also supported for acquiring

memory access in the specified range (memory access address or memory access data) by tracing. Limited Event conditions in ROM and

unlimited Breakpoints in RAM are supported.

User system interface cable for AUD header is not provided with this CPU board. This can be purchased at additional cost from the local

Renesas distributor. A list of worldwide Renesas distributors is available on the Renesas website -

www.renesas.com

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

Sin comentarios

Renesas Single-Chip Microcomputer SH7203 Información técnica Pagina 23