Renesas User System Interface Board HS7047ECH61H Manual de usuario descargar pdf (Pagina 13)

User Manual: RENESAS Flash Programmer

13 www.ngxtechnologies.com

(6) Execute the [Autoprocedure (E.P)] command

Step 1: Click the [Microcontroller] menu and select the [Autoprocedure (E.P)] command. A check mark

is then placed on the left of the command, and the command is assigned to the Start button.

Figure 3-9. Main Window

Step 2: After clicking the Start button, execute the following commands in the following order for

R5F1026A: [Blank Check] command, [Erase] command (if there are no blanks), and [Program]

command.

Remarks

1. When necessary, insert the target microcontroller (microcontroller to be programmed) into the

program adapter, then execute the [Autoprocedure (E.P)] command.

2. When supplying VDD power to the target system, first turn off the power, connect the target system

(for programming), and then turn on the power and execute the [Autoprocedure (E.P)] command.

Step 3: When execution of the [Autoprocedure (E.P)] command ends normally, "--End

(Autoprocedure(E.P)) ------"is displayed on the output panel.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Sin comentarios

Renesas User System Interface Board HS7047ECH61H Manual de usuario Pagina 13