Renesas User System Interface Board HS7047ECH61H Manual de usuario descargar pdf (Pagina 24)

User Manual: RENESAS Flash Programmer

24 www.ngxtechnologies.com

Step 3: When execution of the [Program] command ends normally, “Image written to device” and

“Disconnected” are displayed on the output panel.

Figure 4-16. [Program] Command Execution Results

(7) System shutdown

Step 1: Disconnect the target cable from the target system.

Remark

When supplying VDD power to the target system, turn off the power before removing the target

cable. Furthermore, if [Auto Disconnect] in the [Flash Program Options] category in the [Other

Settings] tab of the [List of Settings] dialog box is set to “False,” remove the target system after

Executing [Disconnect To Device].

Step 2: Unless there are other target microcontrollers to be programmed, click the [File] menu and select

the [Exit] command to close RFP. Because all settings made so far will be saved to a project file, they

can be reused after RFP is restarted.

Step 3: Remove the USB cable from the tool used.

Step 4: To execute the user code supply power using USB cable to the target board and set Boot switch

to 1100 then LED (D2) should blink.

Caution:

If an error occurs during the above procedure, see section TROUBLESHOOTING. Also see the

user’s manual of the tool used and execute diagnostic tests.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29

Sin comentarios

Renesas User System Interface Board HS7047ECH61H Manual de usuario Pagina 24