Renesas H8S/2628 Información técnica descargar pdf (Pagina 267)

100

101

239

[Probe1]: Detects the status of the input probe signal 1

[High]: Detects the high level of the input probe signal

[Low]: Detects the low level of the input probe signal

[Don’t care]: The status of the input probe signal is not detected

(4) [Action] page

Use this page to decide what action the emulator takes when the defined event occurs.

Figure 5.63 [Breakpoint/Event Properties] Dialog Box ([Action] Page)

[Action]: Selects an action that occurs when the event is satisfied. This cannot be used for an

event point being used as the trace acquisition condition.

[Break]: Causes a break (stop) in the user program when the event occurs. This is the

default action.

[Start Timer]: Starts the run timer (the run timer value is displayed in the [Status] window).

[Stop Timer]: Stops the run timer (the run timer value is displayed in the [Status] window).

[Delay after detection before break occurs]:

Sets a 16-bit delay (in bus cycles) after the event has occurred before the action is

taken. The delay is only applicable to break events and there is only one delay counter

in hardware, therefore only one breakpoint can have a non-zero delay. The range of

values is D’0 to D’65,535 (only available when [Break] has been selected). This

cannot be used for an event point being used as the trace acquisition condition.

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 429 430

Comentarios a estos manuales

Sin comentarios

Renesas H8S/2628 Información técnica Pagina 267

Comentarios a estos manuales

Relacionado con productos y manuales para Software Renesas H8S/2628