
4
1.4 Example of E10A Emulator Connection
The figure shown below is an example of connecting the user system to the E10A emulator.
Pulled-up at 4.7 k
User system
User logic
Vcc
E10A pin No.
14-pin connector with
a 2.54-mm pitch
(3M Limited: 2514-6002)
· RES# of pin 4 of the H-UDI port connector is a signal line in which the emulator outputs signals to the MCU.
Connect RES# of pin 4 and the user system reset circuit to the MCU, as shown above.
· RES# of pin 7 of the H-UDI port connector is a signal line in which the emulator monitors the RES# signal of
the MCU. The RES# must be pulled up before it is connected to pin 7 of the H-UDI port connector.
EMLE
PG4
P53
WDTOVF#
PG5
PG6
MCU
RES#
11
1
2
3
5
6
4
7
8 to 10
12 to 14
Figure 1.3 Example of E10A Emulator Connection
Comentarios a estos manuales