Renesas HS2378KCI01H Manual de usuario descargar pdf (Pagina 16)

If the flash memory is rewritten many times, the data will not be erased. If an error message

is displayed, exchange the MCU for a new one.

7. MCU Operating Mode

The E10A emulator does not support modes 1 and 2 (expanded mode with on-chip ROM

disabled mode). Use the E10A emulator in mode 4 (expanded mode with on-chip ROM

enabled) or mode 7 (single-chip mode).

8. Sum Data Displayed in the Writing Flash memory Mode

Sum data, which is displayed in the ‘Writing Flash memory’ mode, is a value that data in the

whole ROM areas has been added by bytes.

9. Note on Executing the User Program

The set value is rewritten since the emulator uses flash memory registers during programming

(Go, Step In, Step Out, or Step Over) of the flash memory.

10. Note on Using the WDT

If a reset occurs by an overflow of the WDT during user program halting, the emulator will

not operate correctly. Do not use the reset function by the overflow of the WDT.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Sin comentarios

Renesas HS2378KCI01H Manual de usuario Pagina 16