
5
Notes: 1. The E10A emulator uses WDTOVF#, P53, and PG4 to PG6 pins. Pull up the E10A
emulator and MCU pins and connect them to the user system connector. Peripheral
functions that are shared by those pins cannot be used.
H-UDI port
connector
4.7 kΩ
MCU
Pins 1, 2, 3, 5, and 6
Vcc
Figure 1.4 Connection of E10A Emulator and the MCU
2. The EMLE pin of the MCU must be pulled up when connecting with the E10A
emulator, and connected to ground when not connecting with the E10A emulator.
The E10A emulator is connected:
EMLE
Vcc
4.7 kΩ
The E10A emulator is unconnected:
EMLE
MCU
MCU
Figure 1.5 EMLE pin and E10A Emulator
Comentarios a estos manuales