Renesas M3T-SRA74 Manual de usuario descargar pdf (Pagina 124)

E8a Emulator User's Manual 6. Tutorial

6.9 Executing the Program

Execute the program as described in the following:

• To execute the program, select [Go] from the [Debug] menu, or click the [Go] button on the

toolbar.

Figure 6.9 [Go] Button

When the program execution is started, ‘**RUNNING’ is displayed on the status bar.

The program will be executed up to the breakpoint that has been set, and an arrow will be

displayed in the [S/W Breakpoints] column to show the position that the program has halted, with

the message [BREAKPOINT] in the status bar.

Note: When the source file is displayed after a break, a path of the source file may be inquired.

The location of the source file is as follows:

The High-performance Embedded Workshop is installed to:

\WorkSpace\Tutorial\E8a\xxxx\Tutorial\Tutorial\Source

The directory xxxx varies depending on each device.

e.g.: M32C

\WorksSpace\Tutorial\E8a\M32C\Tutorial\Tutorial\Source

e.g.: M16C

\WorksSpace\Tutorial\E8a\M16C\Tutorial\Tutorial\Source

e.g.: R8C/Tiny

\WorksSpace\Tutorial\E8a\R8C\Tutorial\Tutorial\Source

e.g.: 740

\WorksSpace\Tutorial\E8a\740\Tutorial\Tutorial\Source

e.g.: H8/Tiny normal mode

\WorksSpace\Tutorial\E8a\H8\Tutorial

e.g.: H8/Tiny advanced mode

\WorksSpace\Tutorial\E8a\H8\TutorialADV

e.g.: H8/Super Low Power

\WorksSpace\Tutorial\E8a\H8\TutorialSLP

REJ10J1655-0400 Rev.4.00 Page 108 of 158

Apr 30, 2010

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 176 177

Sin comentarios

Renesas M3T-SRA74 Manual de usuario Pagina 124