Renesas M3T-SRA74 Manual de usuario descargar pdf (Pagina 173)

E8a Emulator User's Manual Appendix E E8aSCP (E8a Self-Check Program)

Table E.1 Error Messages

Error Message Description

The E8a has failed. The E8a emulator has become faulty.

If this applies to the contents guaranteed in

'IMPORTANT' described in this user's manual, we will

repair or replace your faulty product free of charge.

If this guarantee does not apply to your product's

fault, we will repair the product or replace it with a

new one with extra-charge. However, replacement

will be lower in cost and we recommend that you

purchase a new emulator.

Please connect the User interface cable

with the self-check connector in a correct

direction.

Connect the user system interface cable to the self-

check connector in the correct direction, as shown in

figure E.2, before running the self-check program.

Because the User interface cable was

connected with to self-check connector,

TEST3 was interrupted.

Perform the self-check again from the

beginning.

Execution of TEST3 was halted because the user

system interface cable was not removed from the

self-check connector before starting ‘TEST3 is

running.’

Connect the user system interface cable to the self-

check connector in the correct direction, as shown in

figure E.2, and restart the self-check program from

the beginning.

An error occurred during USB I/O

processing.

The USB cable was disconnected during execution of

the self-check program, or the E8a emulator became

faulty. Execute the self-check program again.

If this error message is displayed again, the emulator

could be faulty.

REJ10J1655-0400 Rev.4.00 Page 157 of 158

Apr 30, 2010

1 2 ... 168 169 170 171 172 173 174 175 176 177

Sin comentarios

Renesas M3T-SRA74 Manual de usuario Pagina 173