Renesas M3T-SRA74 Manual de usuario descargar pdf (Pagina 163)

E8a Emulator User's Manual Appendix E E8aSCP (E8a Self-Check Program)

Appendix E E8aSCP (E8a Self-Check Program)

This appendix describes the troubleshooting procedure that applies the self-check program for the

E8a emulator (E8aSCP).

E.1. Flowchart of the Procedure to Execute the Self-Check Program

Install the High-performance

Embedded Workshop.

(for the first time)

Install the E8aSCP program and the USB driver

for the E8a to the host computer.

▼

Connect the user system interface

cable.

Connect the user system interface cable. At this

point, do NOT connect the USB cable to the E8a.

▼

Connect the USB cable.

Connect the USB cable to the USB connector of

the host computer and the E8a emulator.

▼

Start up the E8aSCP program. Start up the E8aSCP program.

▼

Execute the TEST1 program. Execute the TEST1 program.

▼

Disconnect the user system interface

cable from the self-check connector.

Disconnect the user system interface cable from

the self-check connector.

▼

Execute the TEST2 program. Execute the TEST2 program.

▼

The result of self-checking is

displayed.

The message ‘PASS’ or ‘FAIL’ will be displayed.

‘PASS’: the emulator is working correctly.

‘FAIL’: the emulator has failed.

If ‘FAIL’ is displayed, see Table E.1.

REJ10J1655-0400 Rev.4.00 Page 147 of 158

Apr 30, 2010

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 176 177

Sin comentarios

Renesas M3T-SRA74 Manual de usuario Pagina 163