Renesas SuperH SH7343 Información técnica descargar pdf (Pagina 144)

Target interface (SH7760) Jun. 30, 2009 (Second Edition)

■ SH7760

Applicable products PALMiCE3-SH / PALMiCE2-SH

Applicable connectors

(Connectors for debugger)

MIL connector (14-pin design)

MDR connector (36-pin design)

MIL connector

Signals

CPU Pin No. CPU Pin No. Pin

No.

Signal

Input/

Output

P-LBGA2121-256

No.

Signal

Input/

Output

P-LBGA2121-256

1 TCK Input C15 2 N.C.

3 TRST Input D10 4 GND

5 TDO Output C12 6 GND

7 ASEBRK/BRKACK Input/Output C8 8 VCC

Output

9 TMS Input C10 10 GND

11 TDI Input D12 12 GND

13 RESET Output B1 14 GND

・ For the pin where stated as N.C. in the table, leave the signal unconnected.

*1: Input/output is based on the target system.

*2: For VCC, connect I/O power of CPU. Debugging can be performed even if the signal is N.C., however, by connecting I/O power, leak during

the target system power OFF can be prevented.

Target connection reference diagram

MIL connector specifications

Recommended connector

Manufacturer Omron Corporation

Model XG4C-1431

(Top view on the target board)

(For detailed dimensions of the connector,

refer to the documentation by manufacturer of the connector.)

*Please look at the pin configuration diagram above and make

sure that the connector is in the right direction before connecting.

Please check the pin number in the signal table above and make sure

the signal and the pin numbers match.

*1:

RESET, which is connected to Pin No. 13 of the connector for debugger, is the signal that debugger uses for monitoring the state of RESET

pin of CPU.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 203 204

Comentarios a estos manuales

Sin comentarios

Renesas SuperH SH7343 Información técnica Pagina 144

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Renesas SuperH SH7343