Renesas M38000TL2-FPD Manual de usuario descargar pdf (Pagina 27)

( 27 / 48 )

Setup

This chapter describes how to connect the emulator PC4701U with your host machine and

emulation pod. For details on how to install the emulator debugger M3T-PDxx, refer to the

emulator debugger M3T-PDxx User's Manual (Online Help).

This chapter also explains the emulator PC4701U's self-check and the procedure for

setting up its interface. Before you run the self-check, you must have the emulation pod. If

you use the emulation pod with the emulator MCU method, you must have the emulator

MCU and target system connected to your emulator PC4701U.

Before making connections, be sure to turn off the power to the emulator PC4701U and the

host machine.

4.1 Connecting the Host Machine

When connecting the emulator PC4701U to a host machine, you can choose your desired interface

from LAN interface, USB interface and LPT parallel interface. Use the interface selection switch

on the emulator PC4701U's rear panel to specify your desired interface.

Figure 4.1 shows the outline to connect each interface cable.

Figure 4.1 Outline for interface cable connection

IMPORTANT

LAN interface

LPT parallel interface

Chapter

USB interface

IBM PC/AT compatible

Emulator PC4701U

10BASE-T cable

(separately available)

* Get a commercially available 10BASE-T cable.

USB interface cable

LPT parallel interface cable

7.1 LPT Parallel Interface

Cable (P.45)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Sin comentarios

Renesas M38000TL2-FPD Manual de usuario Pagina 27