Renesas M38000TL2-FPD Manual de usuario descargar pdf (Pagina 29)

( 29 / 48 )

Important

If the LAN interface is used as the PC4701U communication interface, it is necessary to acquire an

IP address of the PC4701U. For details, contact your network administrator.

To register network information, shut power to the PC4701U off and restart. The registered infor-

mation is activated by restarting the PC4701U.

The PC4701U cannot communicate with more than one host machine at a time. It communicates

with the first host machine it connects to.

The initial values of network information for the PC4701U are as follows.

IP address: 39.40.41.43 Subnet mask: 255.255.255.255

Port number: 4700 Gateway: 255.255.255.255 (not in use)

Using the SETIP.EXE

If you use the emulator debugger M3T-PDxx on Windows 95 or Windows NT 4.0, the SETIP.EXE

cannot be used. In this case, register the network information by using the emulator debugger M3T-

PDxx.

Use the utility software SETIP.EXE, which is accompanied by the emulator debugger M3T-PDxx,

to register the network information of the emulator PC4701U by use of the LAN interface. When

the registration of the network information in the emulator PC4701U is completed, you can connect

the emulator debugger M3T-PDxx to the emulator PC4701U by use of the LAN interface.

The setup procedure is as follows.

1. Turn power to the host machine, PC4701U and target system off.

2. Switch the interface selection switch on the rear panel to the LAN side.

3. Connect a 10BASE-T cable to the LAN interface connector of the PC4701U.

4. Turn power to the host machine, target system and PC4701U back on in the given order.

5. Start up SETIP.EXE and register network information in the PC4701U as specified in "Setting

of the LAN Interface using the SETIP.EXE" of emulator debugger M3T-PDxx User's Manual

(Online Help).

6. Turn power to the PC4701U and target system off.

7. Turn power to the target system and PC4701U back on in the given order.

8. Start up the emulator debugger M3T-PDxx. (Select LAN on the MCU tab of the Init dialog box,

the IP address and port number) However, it is not necessary to set the IP address of the gate-

way.

Important

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Sin comentarios

Renesas M38000TL2-FPD Manual de usuario Pagina 29