Renesas Emulation Pod M306H2T-RPD-E Información técnica descargar pdf (Pagina 14)

( 12 / 74 )

Notes on Downloading Firmware:

• Before using this product for the first time, it is necessary to download the dedicated firmware.

Please note that, to do this, it is necessary to start up the emulator main unit in maintenance mode.

For firmware download procedures, see "4.2 Downloading Firmware" (page 48). Once the

firmware has been downloaded, the product can be used by simply turning on the power.

• Do not shut off the power while downloading the firmware. If this happens, the product will not

start up properly. If power is shut off unexpectedly, redownload the firmware in maintenance mode.

• Be sure to disconnect the user system before downloading the firmware.

IMPORTANT

Note on Malfunctions in the PC4701 System

• If the emulator malfunctions because of interference like external noise, do the following to remedy

the trouble.

(1) Press the system reset switch on the emulator front panel.

(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then

reactivate it.

Note on Final Evaluation:

• Be sure to evaluate your system with an evaluation MCU. Before starting mask production,

evaluate your system and make final confirmation with a CS (Commercial Sample) version MCU.

Note on Quitting the Emulator Debugger:

• To restart the emulator debugger after it ends, always shut power to the emulator off once and then

on again.

Notes on the Self-check:

• If the self-check does not result normally (except target status errors), the product may be damaged.

Then, contact your local distributor.

• Be sure to disconnect the user system before executing the self-check. For details on the self-check,

see "4.3 Self-check" on page 49.

Notes on Power Supply to the User System:

• The Vcc terminal of the emulator is connected to the user system to observe the voltage of the user

system. Therefore design your system so that the user system is powered by an external power supply.

• The voltage of the user system should be within the MCU's specified range.

•Do not change the voltage of the user system after turning on the power.

• Before powering on your emulator system, check that the host machine, the emulator main unit,

the converter board and user system are all connected correctly. Next, turn on the power to each

equipment following the procedure below.

(1) Turn ON/OFF the user system and the PC4701 emulator as simultaneously as possible.

(2) When the PC4701 and emulator debugger start up, check the target status LEDs on the

emulator main unit's front panel to see if this product is ready to operate.

• Is the power supplied? Check target status LED (POWER) is ON.

• Is the reset is released? Check target status LED (RESET) is OFF.

For details, refer to "Chapter 4. Usage" (page 45).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Sin comentarios

Renesas Emulation Pod M306H2T-RPD-E Información técnica Pagina 14