Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 115)

E8a Emulator User's Manual 11. Appendix E: E8aSCP (E8a Self-Check Program)

R20UT0541EJ0601 Rev.6.01 Page 115 of 124

Aug 25, 2011

11. Appendix E: E8aSCP (E8a Self-Check Program)

This appendix describes the troubleshooting procedure that applies the self-check program for the E8a emulator (E8aSCP).

11.1 Flowchart of the Procedure to Execute the Self-Check Program

Install the High-performance Embedded Workshop.

(for the first time)

Install the E8aSCP program and the USB driver

for the E8a to the host computer.

▼

Connect the user system interface cable.

Connect the user system interface cable. At this point,

do NOT connect the USB cable to the E8a.

▼

Connect the USB cable.

Connect the USB cable to the USB connector

of the host computer and the E8a emulator.

▼

Start up the E8aSCP program. Start up the E8aSCP program.

▼

Execute the TEST1 program. Execute the TEST1 program.

▼

Disconnect the user system interface cable

from the self-check connector.

Disconnect the user system interface cable

from the self-check connector.

▼

Execute the TEST2 program. Execute the TEST2 program.

▼

The result of self-checking is displayed.

The message ‘PASS’ or ‘FAIL’ will be displayed.

‘PASS’: the emulator is working correctly.

‘FAIL’: the emulator has failed.

If ‘FAIL’ is displayed, see Table E.1.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 123 124

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 115