Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 121)

E8a Emulator User's Manual 11. Appendix E: E8aSCP (E8a Self-Check Program)

R20UT0541EJ0601 Rev.6.01 Page 121 of 124

Aug 25, 2011

Table E.1 Error Messages

Error Message Description

The E8a has failed. The E8a emulator has become faulty.

If this applies to the contents guaranteed in 'IMPORTANT' described in this

user's manual, we will repair or replace your faulty product free of charge.

If this guarantee does not apply to your product's fault, we will repair the

product or replace it with a new one with extra-charge. However, replacement

will be lower in cost and we recommend that you purchase a new emulator.

Please connect the User interface cable

with the self-check connector in a correct

direction.

Connect the user system interface cable to the self-check connector in the

correct direction, as shown in Figure E.2, before running the self-check

program.

Because the User interface cable was

connected with to self-check connector,

TEST3 was interrupted.

Perform the self-check again from the

beginning.

Execution of TEST3 was halted because the user system interface cable was

not removed from the self-check connector before starting ‘TEST3 is running.’

Connect the user system interface cable to the self-check connector in the

correct direction, as shown in Figure E.2, and restart the self-check program

from the beginning.

An error occurred during USB I/O

processing.

The USB cable was disconnected during execution of the self-check program,

or the E8a emulator became faulty. Execute the self-check program again.

If this error message is displayed again, the emulator could be faulty.

1 2 ... 116 117 118 119 120 121 122 123 124

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 121