Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 30)

E8a Emulator User's Manual 3. Preparation before Use

R20UT0541EJ0601 Rev.6.01 Page 30 of 124

Aug 25, 2011

3.5 Connecting the Emulator to the Host Computer

This section describes how to connect the emulator to the host computer. For the position of each connector of the

emulator, refer to section 3.2, Emulator Hardware Configuration.

Notes: 1. When [Add New Hardware Wizard] is displayed, select the [Search for the best driver for your device.

(Recommended)] radio button and then the [Specify a location] check box to select the path to be searched for

drivers. The location must be specified as <Drive>:\DRIVERS. (<Drive> is the CD drive name.)

2. Be sure to install the emulator’s debugger before putting the emulator in place.

WARNING

Warnings for Power Activation:

Always switch OFF the emulator product and the user system before connecting or disconnecting

any cables except for the USB interface cable. Failure to do so will result in a fire hazard and will

damage the user system and the emulator product or will result in personal injury. The user program

will be lost.

The emulator is connected to the host computer via the USB 1.1, and also to the USB port conforming to USB 2.0. Figure

3.8 shows the system configuration.

Figure 3.8 System Configuration when Connecting the Emulator to the Host Computer

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 123 124

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 30